|
|
|
|
#1
28th July 2010, 08:05 PM
|
|||
|
|||
Fixing Nose Cone
Hi all,
Does anyone have a picture of how there nose cone is fixed to the chassis (from the bonnet end to the front) if that makes sense, as mine seems to not much of a lip to put fixings through. Terry 
|
|
#2
29th July 2010, 09:08 AM
|
|||
|
|||
|
Its only a small lip that sits on the chassis inside the nose but there is still room for a couple of m6 bolts on each side rivnutted into the chassis, i cut some big washers almost in half and used these to spread the load a little, i also put another 3 underneath the bottom at the front, again with big washers on them.
|
|
#3
29th July 2010, 08:15 PM
|
||||
|
||||
|
Hi Terry,
I had the same problem. Not enough on mine for a bolt one side so had to adapt and overcome as they say. I'll email you some photos. http://i641.photobucket.com/albums/u...y/DSCN3877.jpg http://i641.photobucket.com/albums/u...y/DSCN3878.jpg Couldn't email, too big so here is some links - hopefully of some help. Last edited by DaddyA : 29th July 2010 at 08:27 PM. Reason: Insert photo links
|
|
#5
30th July 2010, 08:01 AM
|
||||
|
||||
|
I used m5's on mine with speaker washes top and bottom
__________________
My Roadster Is Finished NerNer....... Pigs can fly, you just have to carry them onto the plane. My Pictures http://s707.photobucket.com/user/ashgardiner/profile/
|
|
#6
30th July 2010, 09:09 AM
|
||||
|
||||
|
I'm afraid the mold for the nose cone doesn't allow for much a flange to be formed for fixing of the nose cone. Going to have a go at modifying the mold soon to allow for better fixing.
It does fix on okay at the moment, if not a little awkward. Regards.....AndyH
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
