|
#1
|
|||
|
|||
top belt mounts in cross tube?
anyone know if there are any reasons why a hole cant be drilled all the way through in the cross tube on the roll bar and the threaded tubes welded into them doing away with thoes flat plates?
i think it would be neater and have less edges. |
#2
|
||||
|
||||
Hi Baz
I think that is the way most folk prefer to do them That is certainly the way I am doing mine & I believe Ash done the same Truth be known, I expect most IVA inspectors would prefer to see them done that way.
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie www.roadster-builders.co.uk |
#3
|
||||
|
||||
This is what I did (this drawing was for the benefit of Mr SVA).
Sorry it's a bit small - this forum wouldn't allow me to put anything bigger up... |
#4
|
||||
|
||||
The threaded tube must be welded on both sides of the bar to pass iva.
I did mine as per the book but cut the cross bar out as I felt it was too thin, I bought some new bush tubes off Ronnie and will put them through the bar when the time comes. |
#5
|
||||
|
||||
That's how mine were done.
Gus |
#6
|
||||
|
||||
Mine too .
cheers andy
__________________
Flat Pack Chassis Kits for sale, contact me at andyroadster@yahoo.co.uk |
Thread Tools | |
Display Modes | |
|
|