|
#1
|
||||
|
||||
Welding my nuts
I'm about to weld the seat harness nuts to the CP18s.
The nuts I have are BZP - should I grind the zinc coating off before I weld them? Should these nuts be fully welded all the way round, or just tacked in a few places? Thanks, |
#2
|
||||
|
||||
You want to clean off all coatings on steel before welding, as a general rule. It would be best to fully weld it as its no extra effort, but a massive disaster if the IVA man decides it needs to be fully welded once your car is complete.
Edit: Thinking about it, just a couple of tacks on the lower ones should be sufficient as its just to make fitting easier. The upper ones need fully welding Last edited by deezee : 2nd March 2011 at 11:36 AM. |
#3
|
|||
|
|||
I welded all the nuts complete just to make sure they dont turn it down it really pays to go the extra mile to make sure
|
#4
|
||||
|
||||
I guess it probably is worth fully welding them just to be sure.
I was just a bit worried about the threads distorting if I did. |
#5
|
|||
|
|||
when i weld nuts on i put a bolt through the nut, which keeps the thread nice a clean from weld splatter.
Terry |
#6
|
|||
|
|||
yes and yes
tilly |
Thread Tools | |
Display Modes | |
|
|