![]() |
#1
|
|||
|
|||
![]() Good day
I've searched through past posts about this but I'm still after some help. Bare with all the questions!! ![]() Does any one know if the switch as fitted to my 1.6 pinto will be ok to control the fan on my rad. This is a switch with a green plastic top and single spade on it, right? Is the temp range suitable I mean? Also I was going to fit a tee in there for my water sender and dash gauge, should be ok shouldn't it? I was also going to tee into the oil pressure low switch for my pressure sender, that be ok? Cheers Last edited by will_08 : 25th August 2018 at 07:50 AM. |
Thread Tools | |
Display Modes | |
|
|