#1
|
||||
|
||||
Roll bar spec
Does the roll bar have to be bent?
I have made one in work 50mm OD and 5mm thick, as I was unable to bend it so I did 2 straight uprights, then in at 22.5 deg and the same for the top would this be ok? I put a bevel on all the joints to enable me to get full penetration. Regards Dean
__________________
My Blog: deannoshaynesroadster.wordpress.com (under construction) Being overtaken is a sign of weakness. South Wales Kit Car Club www.southwaleskitcarclub.co.uk WWW.HELPFORHEROES.ORG.UK XBox Gamer tag: D34NNO Last edited by Deanno : 24th July 2011 at 02:59 PM. |
Thread Tools | |
Display Modes | |
|
|