![]() |
#1
|
||||
|
||||
![]() Hi
Could some body tell me as if this the correct way to run the brake pipe from the Sierra's master cylinder to the front and the rear pipes. There are 3 ports from the M/C , the one at the back to the back wheels and the 2 at the front one to O/S and the other to the N/S?
__________________
Regards Axle |
#2
|
|||
|
|||
![]() Dead right with your last paragraph.Back to rear front to left and right.
|
#3
|
||||
|
||||
![]() as Flyerncle has said, just a little further info......
the forward union is off side front center union is near side front rear union is to the rear T piece as when flyerncle & i stripped my car, i bent the bits of cut brake pipe that was still attached to the M/C in the direction they were originally feeding to. ![]() andy ![]() |
#4
|
|||
|
|||
![]() "as when flyerncle & i stripped my car" ? You went home !
|
#5
|
||||
|
||||
![]() cheers lads much appreciated!
__________________
Regards Axle |
#6
|
||||
|
||||
![]() ![]() ![]() but YOU sent me home, by the time i got back with my van you had practically finished stripping the car, remember the look on my face?? ![]() but i do remember bending the bits of brake pipe on the M/C ![]() andy |
#7
|
|||
|
|||
![]() ![]() |
#8
|
|||
|
|||
![]() No probs Jimbo,rear single hole to back, double holes to left and right front.
|
#9
|
||||
|
||||
![]() Quote:
cheers andy ![]() |
#10
|
|||
|
|||
![]() When I said go and get the van I never meant for you to walk down the A19 !
|
![]() |
Thread Tools | |
Display Modes | |
|
|