![]() |
#1
|
|||
|
|||
![]() http://cgi.ebay.co.uk/ws/eBayISAPI.d...#ht_614wt_1165
what ford ignition system is this taken from been trying to work it out |
#2
|
||||
|
||||
![]() It looks like a mash of a few parts. I think it looks like an edis 4 module and coil pack of an early Zetec Escort..... although I welcome a more learned answer
![]() Its hardly a "Megajolt System" as it has no megajolt controller or HT leads and judging by the fact there is no other plugs in the loom, it never was a megajolt system. I imagine all this will do it allow the engine to start and run a limp home mode I.E. not over 2000 rpm. |
#4
|
|||
|
|||
![]() Looks like a module from an OHV escort/Fiesta, an ESC2 module, this will run a coilpack it just needs its own 12v supplies & earths and an input from a crank sensor. Wiring diagrams are easily available on the net, I have heard of folk running Zetecs from this set up, of course this is for spark only, it will not run fuel injection at all, you would need carbs. Dennis
|
#5
|
|||
|
|||
![]() Quote:
it does work loads of people have done it this way as you said loads of info on the web like zetec inside and zetec tiger (i think ) or tiger cat inside ...... the only difference would be if this set was going on a zetec then the trigger wheel wont be used as the zetec triggers the pickup via its flywheel that set up would work on say a cvh or pinto the hardest bit would be to mount that trigger wheel on the front pulley ( probably easier just to buy a new trigger wheel from ahem .......trigger wheels cheers les g |
#6
|
||||
|
||||
![]() As per other posts
It looks to be a mixture of different components Ford EDIS 4 modue Vauxhall ESC module & coilpack I believe that the ESC module is the Vauxhall equivalent of the Ford EDIS system. I have no idea of how the two would manage to work side by side ![]() ![]() The Ford EDIS module will run at 10 degrees BTC without an input signal from elsewhere This is more of a limp home feature of the system & would not run the engine for peak perfomance without a signal from the likes of a Megajolt or the likes. As said in other posts. Spark only, you'll need carbs. Personally I would stick with Megajolt & EDIS if you want to run carbs
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie ![]() www.roadster-builders.co.uk |
#7
|
|||
|
|||
![]() http://www.allcarelectronics.com/ind...453807be087e16
it is a ford part bonzo very similar to edis 4 and no need for a controller |
#8
|
||||
|
||||
![]() Quote:
That should all work fine together in that case. Personally I prefer the mapable option that Megajolt & the likes provide. ![]() I have the wiring diagrams for the EDIS set up if you need them ![]()
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie ![]() www.roadster-builders.co.uk |
![]() |
Thread Tools | |
Display Modes | |
|
|