Quote:
Originally Posted by gingea1pom
Andy I think I might need something a little bespoke.
My original shaft that I have cut in half is 19mm diameter, so either end of the new extension would need to that big internally with enough wall thickness say 4mm.
Then for most of the length it could be turned down to 19mm outside diameter to match the original.
Cheers Ginge.
PS I am only up early as I am of to Weymouth at some point today until Wednesday. I will be taking my dongle hope I get signal.
|
Ginge......
If you can supply some dimensions....length/diameter/couplings needed etc with a drawing then i,m sure Saturn could make something for you , also we,d need to take into account the prob that Ash encountered where as his upper coupling was deemed to be too close to the CP16 bulkhead.
We,d be happy to help out if we can for you.
cheers
andy
22nd February 2010, 07:56 AM
Threaded Mode