#1
|
|||
|
|||
Track Rod Issue
I seem to have a problem with the track rod ends,
The hole in the sierra uprights is 14mm at the wide end but the rs2000 track rod is only 12mm at the base. P8100099.JPG Could someone please check there track rods and uprights measurements for me thanks. Terry Last edited by tkpm : 10th August 2010 at 07:35 PM. |
#2
|
||||
|
||||
?
It's tapered so the TRE should go in and stop. TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#3
|
||||
|
||||
why RS2K TRE by the way is should be a sierra one to match the sierra hub.
TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#4
|
|||
|
|||
I if memory serves me right, the book say's to use them.
Terry |
#5
|
||||
|
||||
The book says use sierra ones?
|
#6
|
||||
|
||||
The rs2000 ones are from rally design, which is also the reason for the problem with the length of the extensions.
They will fit they are tapered, if you push the rubber down a bit you will see it gets wider. |
#7
|
|||
|
|||
Thanks for the help guys, i new i couldn't trust my memory, doh
SeriesLandy, if i push the rubber all the way down, it's still a bad fit. I bought one of these kits from EDS-Motorsport, http://cgi.ebay.co.uk/Front-Hub-Join...item5adb4128a0 Will order the Sierra ones tomorrow Once again thanks for the help and advice. Terry Last edited by tkpm : 10th August 2010 at 11:05 PM. |
Thread Tools | |
Display Modes | |
|
|