#1
|
||||
|
||||
tunnel tops ( q for spud mainly )
Is it normal with the Saturn bulkhead pannel to pannel underneath it in the tunnel area will ally, if not, which rails do i need to pannel up to?
Ta
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#2
|
||||
|
||||
Hello TT,
Sorry TT but i've just seen this one, sometimes when i click on new threads i dont always get all the latest ones. Anyhow, the front of the grp scuttle sits about 2" forward of TR9, between TR8, so whether you are fitting the grp bulkhead or the ali one you need to panel the top of the tranny tunnel about 3" forward of TR9 to meet the bulkhead. Hope this helps.....AndyH
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH |
#3
|
||||
|
||||
LOL.. Think I chopped 3" off the front of my sheet to make it level with TR9..
Oh well No real issue making an infill.. Cheers TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#4
|
||||
|
||||
Sorry, need to be more on the ball.....
No problem making an infill TT you dont see that part for the scuttle anyway, you'll probably need to cut holes through it anyway for you loom to pass through. Good Luck...AndyH
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH |
Thread Tools | |
Display Modes | |
|
|