#21
|
|||
|
|||
Hi NJ nice neat angles what saw are you using, I use a rage3 chopsaw its' just interesting to know what different builders are using
Arfon p.s. when the angles are to great its' back to the good old fashioned hacksaw |
#22
|
|||
|
|||
Quote:
Yup cutting the two BR's with 70degs angle (don;t have manual to hand, cba walking to garage lol) atm with a hacksaw |
#23
|
|||
|
|||
Provided you clamp the box section down it cuts it fine, I also had bought it to build a deck so makes sense to use it for the build
Arfon |
#24
|
|||
|
|||
Your welds look nice and neat.
Its hard to see the heat effected zone on the picture (the oval of discolouration around the weld) It can be used to indicate penetration on some of the welds I would expect to see a little more. The top left weld has a nice zone showing where as the top right one doesn't have as much and tails off towards the end of the weld. but I wouldn't worry they look at lot better than others I have seen. M
__________________
Build Cost so far £xxx (Given up adding it up) - She Starts!! Build Thread Here: http://www.haynes.co.uk/forums/showthread.php?t=5501 |
Thread Tools | |
Display Modes | |
|
|