![]() |
#21
|
||||
|
||||
![]() That looks very much as if it has been made by welding 2 short sections of square ( ish ) tube onto the round shaft.
The square sections are then placed into each end of a longer section of matching profile tube. The top of the assembly fully welded with the bottom section left with the ability to slide ( colapse ) in the event of a frontal impact. Very similar way as the Sierra reach adjust set up in which a triangular section is used in the upper section of the column. With a little luck that'll all make sense ![]() ![]()
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie ![]() www.roadster-builders.co.uk |
#22
|
||||
|
||||
![]() seems like a good & safe way to make the extension , maybe even make the colapsible part longer. i will for sure be making mine the same way, it´ll also make it easy to take appart .
samy |
![]() |
Thread Tools | |
Display Modes | |
|
|