|
|
#1
22nd April 2012, 04:04 PM
|
|||
|
|||
Chassis plate missing hole diameter in plans CP10
Started to make the plates for the chassis and have got to CP10 and have noticed that the dimensions are missing for the 2 holes as seen below...
 Could someone please let me know what size these have to be? Cheers. 
|
|
#2
22nd April 2012, 04:46 PM
|
||||
|
||||
|
We put a pair of 12mm holes in these.
__________________
Website http://www.talonmotorfabrication.co.uk/ Direct email phil@talonmotorfabrication.co.uk talonmotorfabrication@gmail.com Mobile office hours 07514098334
|
|
#3
22nd April 2012, 04:48 PM
|
|||
|
|||
|
Have a look at DS2 that it bolts too. 13 mm clearance hole
 Its for an M12 Bolt
__________________
http://www.flickr.com/photos/29404787@N03/ http://www.flickr.com/photos/41021922@N03/ http://www.flickr.com/photos/56936222@N04/ http://www.flickr.com/photos/79486076@N06/ Finished my roadster after 5 years! Number 27! Last edited by Spikehaus : 22nd April 2012 at 04:52 PM.
|
|
#4
22nd April 2012, 05:20 PM
|
|||
|
|||
|
Brilliant. Thanks both.
|
|
#5
22nd April 2012, 06:40 PM
|
||||
|
||||
|
Mine are 12mm
__________________
My Roadster Is Finished NerNer....... Pigs can fly, you just have to carry them onto the plane. My Pictures http://s707.photobucket.com/user/ashgardiner/profile/
|
|
#6
22nd April 2012, 10:47 PM
|
|||
|
|||
|
Drilled these out to 12.5mm. Should be sweet. Going to start a project thread later on.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
