|
#1
|
|||
|
|||
RS1,2and 3 to BR12
Hi all, I have welded RS 1,2 and 3 as per the book, when I came to mount onto BR12 my measurement is out by 3.1mm. The drawing on page 43 shows the distance from the rear face of BR12 to the outside of RS3 to be 406.9mm, I get 410mm. RS2 and 3 are exactly to the book measurement. Has anybody had this problem? this 406.9mm dimension looks important as this is where the hangers for the lower wishbone fit. If I put RS 2 and 3 onto the edge of BR12 my measurement is correct, but then there is no room for CP 1 and 2. Am I missing something? any help would be appreciated.
Cheers Shaun |
#2
|
|||
|
|||
Done, sorted, small mistake on my part.
|
#3
|
||||
|
||||
Sorry Shaun, I totally missed this thread
Glad you got it sorted tho, nice one Hope all is ok with your kit? You know where I am if I can help anytime. cheers andy
__________________
Flat Pack Chassis Kits for sale, contact me at andyroadster@yahoo.co.uk |
#4
|
|||
|
|||
Hi Andy, no problem, I left too much room on the end for the endplates.
All well with the kit, I am busy with the transmission tunnel at the moment, so far so good I will post some pics in my build diary when I download all the pics off the camera. |
#5
|
||||
|
||||
Nice one , sounds like you are really cracking on with your build
I look forward to seeing the photos of your progress Is there something in the water down there? as there are quite a few builds in progress with my kits in your area cheers andy
__________________
Flat Pack Chassis Kits for sale, contact me at andyroadster@yahoo.co.uk |
#6
|
|||
|
|||
I think it's the weather, haha
we might have to set up a roadster club in the south..... |
#7
|
|||
|
|||
Rs 1,2,3 (p43)
Quote:
I have got the same problem and am pulling my hair out....dont suppose you could walk me through what went wrong with yours? Thx Martyn |
Thread Tools | |
Display Modes | |
|
|