#1
|
|||
|
|||
top belt mounts in cross tube?
anyone know if there are any reasons why a hole cant be drilled all the way through in the cross tube on the roll bar and the threaded tubes welded into them doing away with thoes flat plates?
i think it would be neater and have less edges. |
#2
|
||||
|
||||
Hi Baz
I think that is the way most folk prefer to do them That is certainly the way I am doing mine & I believe Ash done the same Truth be known, I expect most IVA inspectors would prefer to see them done that way.
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie www.roadster-builders.co.uk |
#3
|
||||
|
||||
This is what I did (this drawing was for the benefit of Mr SVA).
Sorry it's a bit small - this forum wouldn't allow me to put anything bigger up... |
#4
|
||||
|
||||
The threaded tube must be welded on both sides of the bar to pass iva.
I did mine as per the book but cut the cross bar out as I felt it was too thin, I bought some new bush tubes off Ronnie and will put them through the bar when the time comes. |
#5
|
||||
|
||||
That's how mine were done.
Gus |
#6
|
||||
|
||||
Mine too .
cheers andy
__________________
Flat Pack Chassis Kits for sale, contact me at andyroadster@yahoo.co.uk |
#7
|
|||
|
|||
ok all i need now is a 20mm drill bit with a shank that will fit my drill (13mm)
where can i get one of them from? |
#8
|
|||
|
|||
You need a "blacksmiths" bit which has a 13mm diameter shank. Tool Station stock them.
Cheers John |
#9
|
||||
|
||||
Here you go Baz
20mm Blacksmith Drill bit Blacksmiths drill bits are available in a range of larger sizes, have a reduced shank & are well suited to use in a hand drill Just remember to choose a slow drill speed
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie www.roadster-builders.co.uk |
#10
|
|||
|
|||
dam i was hoping with a reply i got one you can use
lol |
Thread Tools | |
Display Modes | |
|
|