|
#1
|
||||
|
||||
Grub screw hole size for threading!
Here we go then.
I am planning to drill the holes for the grub screws in my Sierra uprights. I vaguely remember from a fitter machinist / bench fitting lesson 18 years ago that there is a formula for working out the size of hole required when tapping a thread. I am planning on using these (M8 Grub screws). Therefore (Oh cleaver people) what size hole should I be drilling. Thank you in advance. Next If I bring my uprights to Stoneleigh could someone bring a M8 Tap to tap the thread in my new holes. Standing by. Cheers Ginge
__________________
Sent from my iPad, from who knows where in the world I was building but I am not now! Build Pictures Build Thread |
#2
|
||||
|
||||
If my failing memory is still functioning a 7mm hole works just fine for std M8 which is 8x1.25
__________________
Regards (The mad Sarf Efriken) |
#3
|
||||
|
||||
Nice one,
If it supposed to be an odd size like 7.2mm just say as I have a rare selection of drill bits. Just need someone with an M8 tap now. I appreciate it might be a little far for you!!!! Cheers Ginge
__________________
Sent from my iPad, from who knows where in the world I was building but I am not now! Build Pictures Build Thread Last edited by gingea1pom : 13th April 2010 at 07:36 PM. Reason: realising we are a global forum |
#4
|
||||
|
||||
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#5
|
||||
|
||||
Cheers men,
Thanks TT, obviously I could have done that myself but didn’t so other forum members would benefit. I know it is probably imposable to see from the picture and I should really give them a bell in the morning but does the grub screw in the picture look course or fine. I am hoping course as it can only be one hole size opposed to the three hole sizes for different pitches of fine thread. This kit car building is a mine field
__________________
Sent from my iPad, from who knows where in the world I was building but I am not now! Build Pictures Build Thread |
#6
|
|||
|
|||
If you are going past Bracknell in the near future bring em along and I can drill em and tap em for you.
Dave. |
#7
|
||||
|
||||
Just Google for "tap drill sizes". It's a 6.8 mm drill for M8. In general, the formula is D - 1.08 * p, but some lists recommend D - p. (D -- outer diameter, p -- pitch).
__________________
Albert Haynes Roadster FAQ | Haynes Builder Locations Gallery, build thread in Lithuanian / via Google Translate. |
Thread Tools | |
Display Modes | |
|
|