![]() |
|
#1
|
||||
|
||||
![]() A couple of points are coming to light here, firstly the question of the correct taper, I'm using Granada uprights and I'll check them for the taper before I go reaming anything out. Secondly is a comment someone made about using a reamer, you do not use it like a tap. You should never turn a reamer backeards as it blunts the cutting edge. With a tapered reamer you simply lift it out of the hole every so often while turning it forwards.
D.
__________________
visit my website at www.cossie.davenewell.co.uk |
#2
|
||||
|
||||
![]() Quote:
Ray ![]() |
#3
|
||||
|
||||
![]() Quote:
D.
__________________
visit my website at www.cossie.davenewell.co.uk |
#4
|
||||
|
||||
![]() Davey this is a forum and your entitled to your opinion
but im right and your wrong lol never mind moving on .3mm is about 12thou so over 8cm is about 1.5 over 1cm so not really alot in it to worry about so either should be fine Ray ![]() |
#5
|
||||
|
||||
![]() Ray I'll agree to disagree with you
![]() D.
__________________
visit my website at www.cossie.davenewell.co.uk |
#6
|
||||
|
||||
![]() Thank god thats all over.......so about this reamer where's it from and what does it do again??? only joking
![]() ![]() ![]()
__________________
Website http://www.talonmotorfabrication.co.uk/ Direct email phil@talonmotorfabrication.co.uk talonmotorfabrication@gmail.com Mobile office hours 07514098334 |
#7
|
||||
|
||||
![]() Quote:
It cuts a hole the wrong shape, but the differance over the distance is so small it does not matter. ![]() It's available from all good carpet suppliers by all accounts. ![]() TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
![]() |
Thread Tools | |
Display Modes | |
|
|