Gaps between GRP panels and chassis rails

[voucht]

I completed the work by put nice slick trim on the edges. The curvy part of the side panel does not go up to the foot of the roll bar, but I'm not unhappy with the result.

The trim goes from the rear tube to the dashboard, and it is not that bad.

2014-10-04_16-58-33 by Sylvain ROIG, sur Flickr

2014-10-04_16-58-41 by Sylvain ROIG, sur Flickr

Hope that helps

[jps]

Originally Posted by voucht

I completed the work by put nice slick trim on the edges. The curvy part of the side panel does not go up to the foot of the roll bar, but I'm not unhappy with the result.

The trim goes from the rear tube to the dashboard, and it is not that bad.

2014-10-04_16-58-33 by Sylvain ROIG, sur Flickr

2014-10-04_16-58-41 by Sylvain ROIG, sur Flickr

Hope that helps

Cheers- I really appreciate the pics - my first thought was to loose the return on that curve entirely so the line of the original metalwork is followed on the outside and somehow trimming the vertical edge so it has a nicer finish on it. Your solution - to effectively 'cut the top off' the curve - does make sense and looks fine I think!

I am fairly sure I have no other room for adjustment as the panel sits pretty tight on the rails down the whole side of the car - I may even need to sand out the returns on the inside slightly to try and introduce a bit more space to work...!