|
|
#1
8th February 2014, 05:26 PM
|
||||
|
||||
Fitting a loop harness?i
Hi guys, my kit car was fitted with a 3 point harness but didnt come with any harness. i have got a set of harnesses but i am struggling to find a fitting to get the rear connected up, it is a stitched in loop, originally for going around the roll cage or something, i can get a bar made to go around the back for the loop to go around but i was wondering if there is a way to fit it to this point in the pic below.
 cheers wolly 
|
|
#2
8th February 2014, 06:21 PM
|
|||
|
|||
|
To be honest it looks that corroded I don't think I would like to chance it
Arfon
|
|
#3
8th February 2014, 06:33 PM
|
||||
|
||||
|
Quote:
|
|
#4
9th February 2014, 08:31 PM
|
|||
|
|||
|
http://www.racereadyproducts.com/mou...ting-hardware/
american I know but I am sure deamon tweeks will do similar.
|
|
#5
9th February 2014, 08:37 PM
|
|||
|
|||
|
or make one. decent bit of steel and an anville. :0)
|
|
#6
10th February 2014, 09:29 AM
|
||||
|
||||
|
So your saying just extend the strap in the loop as long as it will go, then cut it and fit a new harness fittings.
cant see why not, cheers.
|
|
#7
10th February 2014, 12:43 PM
|
|||
|
|||
|
If you cut it in any way don't forget to seal the end by melting it together again.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
