|
|
#1
8th December 2011, 11:35 PM
|
|||
|
|||
Steering column extension tube
Does anyone know where to get the tube to extend the steering column and what kind of price I should pay?
Cheers David
__________________
Click to see my build photos on Flikr http://www.flickr.com/photos/67112582@N03/ Saturn MX5 Based Chassis, Limited Slip Diff & 2.4 Quick Rack. Build cost.... seems to be spending more on tools than car bits at the moment! (they will be handy in the future though). Car iva'd and passed 15/08/2014. Finished weight 572kg. 
|
|
#2
9th December 2011, 09:21 AM
|
||||
|
||||
|
Try http://stores.ebay.co.uk/Metal-Mania...id=p4340.l2563
P&P bit steep though. or ebay ??mm steel tube.
__________________
Be Lucky, Mike. 
|
|
#3
9th December 2011, 09:48 AM
|
||||
|
||||
|
We have some 3mm wall tube here you can use David, if you measure your column length and bring it down we'll weld it up no probs.
AndyH
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH
|
|
#4
9th December 2011, 11:17 AM
|
||||
|
||||
|
You might also need a "group 4 " coupling & a splined shaft to connect your extension to the rack, both available from Rally Design, maybe Saturn has them in stock too ( not sure ).
I think the splined shaft is approx £22 & coupling approx £15. It all depends how you intend to make the connection from steering wheel to rack on what bits you,ll need, plus the 3mm wall tube as above from Saturn. cheers andy
|
|
#5
10th December 2011, 10:40 PM
|
|||
|
|||
|
Thanks Spud and Andy. I am going to get the coupling and extension bar as soon as possible. I will then pop down with the bits and the measurements to get it welded up but will probably be after xmas. In the mean time I am in the process of fitting the metal brake lines which is good fun.
__________________
Click to see my build photos on Flikr http://www.flickr.com/photos/67112582@N03/ Saturn MX5 Based Chassis, Limited Slip Diff & 2.4 Quick Rack. Build cost.... seems to be spending more on tools than car bits at the moment! (they will be handy in the future though). Car iva'd and passed 15/08/2014. Finished weight 572kg.
|
|
#7
11th December 2011, 10:22 PM
|
|||
|
|||
|
thanks Baz. The column I am using is from a MX5 so it will hopefully fit.
__________________
Click to see my build photos on Flikr http://www.flickr.com/photos/67112582@N03/ Saturn MX5 Based Chassis, Limited Slip Diff & 2.4 Quick Rack. Build cost.... seems to be spending more on tools than car bits at the moment! (they will be handy in the future though). Car iva'd and passed 15/08/2014. Finished weight 572kg.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
