|
|
#1
22nd April 2011, 09:45 PM
|
||||
|
||||
Exhaust cat shield.
Not sure on which section to post this, so it's going here. lol
I knocked up this shield to protect the sharp edges on the cat for IVA. Just wondering if the IVA man's tool will fit in the gap?  Thoughts please people. Cheers Dave   
__________________
~ My Build Diary - http://davesroadster.blogspot.com/ *updated 7/6/11* Best bit so far: Getting it running Worst bit so far: Cutting steel for wishbones and engine mounts. Most annoying bit so far: Generator packing up half way through welding. 
|
|
#2
24th April 2011, 08:52 AM
|
||||
|
||||
|
Anyone?
__________________
~ My Build Diary - http://davesroadster.blogspot.com/ *updated 7/6/11* Best bit so far: Getting it running Worst bit so far: Cutting steel for wishbones and engine mounts. Most annoying bit so far: Generator packing up half way through welding.
|
|
#3
24th April 2011, 10:27 AM
|
||||
|
||||
|
No idea about the IVA aspect but it does look good
|
|
#5
8th July 2011, 01:36 PM
|
||||
|
||||
|
How did you get on with this bit during your recent test Dave? I'm thinking of making something similar to cover the cat / exhaust to try and stop the mrs getting a burnt leg!
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
