|
|
#1
3rd April 2011, 09:28 PM
|
|||
|
|||
half shafts
Today got my diff..if believe the sources from Internet,I have 7,5'',3.64:1 LSD from granada(85GG4006ACA)..
 but I do not have half shafts... Do they are in different lenghts in sierra models?or I need to get Granada's one? To what I must pay attention choosing half shafts?
|
|
#2
3rd April 2011, 10:15 PM
|
|||
|
|||
|
Nomally they differ in length due to the offset of the crownwheel and the outer ends are left and right hand thread.
Left on the offside and right on the nearside.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#3
4th April 2011, 12:01 PM
|
|||
|
|||
|
Thank for help.Today I found good one for bargin price..2 bottles of vodka
Remaining to buy cirslips..One more question-in my build I will use disks on rear,so I have Tripod style driveshafts,but my diff has Lobro style..Is it possible to fit tripod shaft end(wheel hub) to Lobro driveshaft?Also drive shafts have diff.lenghts...May be somebody done this before and can to share? Or can somebody tell the total lenght of driveshafts needed for build roadster?
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
