#1
|
|||
|
|||
Slitting discs ..These are really good !!
http://www.toolstation.com/shop/Powe.../sd1750/p13340
Bought a box of these today ..have been cutting 4mm plate and 48mm pipe for roll bar ..still have loads of wear on the first disc .!! been using Erbuer ones wich were crap and wore out after one slice at the plate ... |
#2
|
||||
|
||||
Nice to see another brand of hard wearing slitting discs
My current batch have been quite good & are hard wearing ( Can't remember the brand ) Use them quite extensively for quite a few years now That said, they still give me the proverbial willys using them
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie www.roadster-builders.co.uk |
#3
|
|||
|
|||
I bought these expecting them to be crap because of the price.
http://cgi.ebay.co.uk/1mm-Cutting-Di...item20b75b28c1 Very surprised. I cut through two pieces of 40mm mild steel bar a couple of days ago and the disc didn't reduce by 1/4". Been using them to cut chassis plates,diff plates etc and still got ten left. A definite reccommendation from me. Gaz
__________________
Total cost so far Materials £3,150 Tools £855 |
#4
|
||||
|
||||
Slitting disc.
In my job i buy 200 @ a time for about the same price as GAZ found http://cgi.ebay.co.uk/1mm-Cutting-Di...item20b75b28c1, you need to check that they are classed as INOX as this is the correct type for stainless and last a long time cutting mild steel.
__________________
Be Lucky, Mike. |
#5
|
||||
|
||||
i got some makita ones once as thats all they had left. i have never gone back nothing gets close to them
__________________
My Roadster Is Finished NerNer....... Pigs can fly, you just have to carry them onto the plane. My Pictures http://s707.photobucket.com/user/ashgardiner/profile/ |
#6
|
||||
|
||||
I used the ones from skroofix.
They are cr*p. 1 disc one cut ( If ya lucky)
__________________
. . David. Heaven, Warm days and Cool rides |
#7
|
|||
|
|||
I've got some of the Screwfix ones left in the garage. Haven't touched them since I bought the ones in the link.
__________________
Total cost so far Materials £3,150 Tools £855 |
#8
|
||||
|
||||
Quote:
Sorry, i'll get my coat
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie www.roadster-builders.co.uk |
#9
|
||||
|
||||
when buying them look for ones wirh inox in them as they last longer than aluminium oxide variants
__________________
My Roadster Is Finished NerNer....... Pigs can fly, you just have to carry them onto the plane. My Pictures http://s707.photobucket.com/user/ashgardiner/profile/ |
#10
|
|||
|
|||
now i bought these
http://cgi.ebay.co.uk/ws/eBayISAPI.d...=STRK:MEWNX:IT 50 off for £16 ish about 34p per disc i hadnt used them till today and i was very surprised used one where normally id have used 3-4 cutting 3mm plate shame my grinders letting go had it in bits earlier trying to chase a "new noise " but no joy. it still works but holding it at arms length with your eyes closed hiding behind some 3mm ali the cuts arent so accurate
__________________
theres a box ! im not allowed in it ! i have to think outside ! |
Thread Tools | |
Display Modes | |
|
|