|
|
#1
16th August 2011, 09:06 AM
|
||||
|
||||
cvh manifold studs
Wanted to replace my inlet & exhaust manifold studs, can anyone confirm that these are just m8 by 50mm or are they some sort of imperial size?
|
|
#3
16th August 2011, 01:03 PM
|
||||
|
||||
|
Ya I've just bought some from there as well. I like how they have a torx bit at the top to make getting them in/out easier. Is it worth trying to get the old studs out that are stuck or just leave them even if they're rusted?
|
|
#4
16th August 2011, 02:45 PM
|
||||
|
||||
|
If they are just rusty and untidy, I'd soak em in wd40 and wire brush them. Then run a die over the thread to freshen them up. If they are in need of replacing, just soak them in wd40 for a day before trying to undo them.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
