|
|
#1
5th February 2011, 07:48 PM
|
|||
|
|||
A question to Andy/Spud
Guys i am going to purchase a saturn scuttle panel (when funds allow) if i make my Bulkhead panel to "book spec" ie 230mm height will i have any issues when i go to fit the scuttle...would be good to know the radius of the corners if possible ??
|
|
#2
5th February 2011, 08:32 PM
|
||||
|
||||
|
Spud knows more about the bodywork than me but I,m pretty sure Spud has put up a post giving the dimensions & the radius, I,ll have a look & see if I can find the post & link it here.
cheers andy
|
|
#3
5th February 2011, 09:58 PM
|
||||
|
||||
|
I,ve found this ......Its a post by Forum member Alga, there are some drawings with dimensions
http://fridge.pov.lt/~alga/dxf/ click on the 4th link ( at the bottom of the list) Hope it helps. cheers andy Last edited by HandyAndy : 5th February 2011 at 10:11 PM. Reason: gramma...doh
|
|
#4
5th February 2011, 10:06 PM
|
|||
|
|||
|
Spot on Andy...jsut what i need for tomorrows job !!...congratulations to your Callum bet your chuffed with him....as for training him do you not have some dogs that enjoy running....dog running duties !!
|
|
#5
5th February 2011, 10:11 PM
|
||||
|
||||
|
Quote:
 the more dogs I attach to him the faster he will go,  Glad the linky helps, cheers andy
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
