#1
|
|||
|
|||
wheel spacers
hi
i'm after a pair/set of 4 wheel spacers for sierra front hubs 8-10mm thick hubcentric if poss. has anybody got any knocking around they dont want or where is the best place to get them. cheers steve |
#2
|
||||
|
||||
10mm spacers will just be a straight through job I would have thought so don't need to be off set and threaded. You can buy +10 +20mm longer wheel studs from rally design or burton if their going on a roadster. To be honest the longer studs won't be to stressed unless you have made your chassis from solid bar,clad it in lead sheet and you weight 60stone. A good machine shop could knock those up in about an hour (ish). Unless your talking about the rings that pack out the centre mouting ring?
__________________
Website http://www.talonmotorfabrication.co.uk/ Direct email phil@talonmotorfabrication.co.uk talonmotorfabrication@gmail.com Mobile office hours 07514098334 Last edited by Talonmotorsport : 1st August 2011 at 08:58 PM. |
#3
|
|||
|
|||
a simple laser cut shim would be cheap and simple
|
#4
|
||||
|
||||
I'm not sure if a laser cut plate would be balanced enough, don't forget that a laser cutter still uses compressed gas to clear the cut and on 10mm plate would be quite rough.
__________________
Website http://www.talonmotorfabrication.co.uk/ Direct email phil@talonmotorfabrication.co.uk talonmotorfabrication@gmail.com Mobile office hours 07514098334 |
#5
|
|||
|
|||
thats how the last set i seen was made no turning or drilling just a plated laser cut ring with all sorts of holes to suit diffrent stud patterns and it was 8mm thick
thay where for the guys nexdoor arckley (triumph rebody) where i used to live Last edited by baz-r : 2nd August 2011 at 05:22 PM. Reason: typo |
Thread Tools | |
Display Modes | |
|
|