#1
|
|||
|
|||
XJ12 temp gauge with pinto water temp sender
Hi,
I liberated nice temperature and fuel gauges from a scrapped Jag XJ12. Any ideas how to hook up to temp gauge to the temperature sender. I've experimented with a couple of configurations, but I either get no movement or the needle goes over to the far right. Do I need to put in a resistor or something? Or can I get a sender which will "drive" this gauge correctly? If it helps, the brass spade connector has at '+' symbol embossed on the plastic beside it. Images below... http://www.flickr.com/photos/kenpower/7093496169/ http://www.flickr.com/photos/kenpower/7093495933/ I have (unscientifically) recorded the response from the pinto water temp sender. The results on a google chart are here. https://docs.google.com/spreadsheet/...lX3E4Y3dVQ lE This might help someone figure out how I should connect the gauge. |
Thread Tools | |
Display Modes | |
|
|