#1
|
|||
|
|||
D1 And D2
Hi
Can someone please help me, I have started to fit the diagonals to my chassis. However D1 and D2 dont look right. I know they will not line up perfectly with the uprights and top/bottom rails but I do not want any issues when fitting side panels. Do I need to inset D1/2 so the allloy panel will fit flush between the upper/lower rails. Or do I line up the outside edge of D1/2 with the rails, if so, will the panel be shaped aroung the material that protrudes as a result of this? Hope this makes sense to somebody |
#2
|
||||
|
||||
Middled mine if that helps.
If using an alloy side panel there is a fold there & should not foul those two diagonals. I believe the Saturn side panel will not foul those either Pesonally I doubt it will make too much difference if you middle them or set them to the outer edge. ( I middled them because it just looked to be the right thing to do )
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie www.roadster-builders.co.uk |
#3
|
|||
|
|||
Thanks Bonzo, yeah I think middling them would be the way to go. Still get strength but looks a lot neater.
Cheers, thats what I will do Leigh |
#4
|
||||
|
||||
Spot on there Ronnie , the GRP side panels don,t come into contact with these diagonals.
cheers andy |
#5
|
||||
|
||||
I found it easyer to fit after I had cut them out of 19x19 & not 25x25
|
#6
|
|||
|
|||
Hi mate dont make the mistake I made, got so carried away cutting up my diagonals, that I cut them out of 25mm not 19mm, bet your gonna double check what you have cut them out of ha ha
|
Thread Tools | |
Display Modes | |
|
|