|
|
#1
4th June 2011, 08:41 PM
|
||||
|
||||
Fuel pipe size?
I'm about to run my fuel lines and just wondering what size I should use.
I've got some 10mm copper pipe that I had in the garage is it ok to use that and change the 8mm barb on the carb to a 10mm one or do I need to run 8mm copper pipe? Does anyone know the thread? Also do I need to run a return or can I do it later if needs be. Currently running a pinto on standard carb. 
|
|
#2
4th June 2011, 08:47 PM
|
|||
|
|||
|
If you have any intention of going injection fit two 10 mm pipes,fit two anyway and it will save you hassle later.
Better too much than too little.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#3
4th June 2011, 08:58 PM
|
||||
|
||||
|
I'll go for 10mm then, save me a couple of quid ect.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
