#1
|
|||
|
|||
Ride height for locost
Can anyone advise on ride height please. The car we are building appears very low, not put the engine and box in yet !
|
#2
|
||||
|
||||
Is the car you are building a Roadster?
if so, you are looking for about 4 to 5 inches of ground clearance from the tarmac to the bottom face of the bottom chassis rails. hope that helps. cheers andy
__________________
Flat Pack Chassis Kits for sale, contact me at andyroadster@yahoo.co.uk |
#3
|
||||
|
||||
Quote:
But yes Handy is correct, 4 to 5 at front and 1" higher at the rear. AndyH
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH |
#4
|
||||
|
||||
mine is 120mm front about 135mm at the back.
|
#5
|
||||
|
||||
Not when I get in it, it aint.....
Had loads of probs getting mine higher at the back than the front. 125mm at the front,..... back.....hmmmm
__________________
. . David. Heaven, Warm days and Cool rides |
#6
|
|||
|
|||
Thanks that helps a lot. Many thanks for all your post
Regards Andy (AP-KIT) |
#7
|
||||
|
||||
What! Another Andy! Right, we're going to have to cap the number of Andy's on the Forum. I'll think of some alternative names and the next Andy to join will just have to be called Sandra or Julian.
|
#8
|
|||
|
|||
lol will that be an "andy capp" think we need to get a couple of flows on board
|
Thread Tools | |
Display Modes | |
|
|