zetec flywheel from a mk1 focus

[jmh]

Hi all,

still looking at flywheels for a zetec to type 9 setup. Have found loads of flywheels for the 1.8 zetec focus. So my question is whether or not this flywheel will work?

thanks in advance,

Jonathan

[mark]

Yes that should be ok, im using a 1.8flywheel/mk1 mondeo clutch kit/ct133 release bearing and its fine

No issues whatsoever simple bolt together stuff

[jmh]

Cheers,

I already have most of the rest of it, just trying to make sure I get the right flywheel.

Then I can get it all together.

[mark]

Mine was from a silvertop to be exact, i was going to reuse the cvh one from my old set up as its lighter, but i went for the zetec flywheel in the end so i didnt have to mount a trigger wheel on the bottom pulley for megajolt