Aerocatches

[davidimurray]

Has anyone used any of these with a saturn bonnet? If so have you used the flush fit or exterior mounted ones?

[Deanno]

I was planning on using the locking ones but not sure about IVA?

[davidimurray]

According to IVA, if the projection sticks out less than 5mm then the edges need to be blunted. According to the aerocatch drawing - http://www.aerocatch.com/updoc/Tech_...flush_dims.pdf if you use the ones that mount externally then they only stick out 2.5mm so should be ok.

The flush mount ones need a bonding plate so the bonnet would need to be less than 2.5mm thick.

[james3004]

I pesonally think the top mounted ones would look better, but I think you need 2 sets to secure the bonnet properly?

I have been looking for an alternitive the the rubber things, they look awful

[SeriesLandy]

I bought a set of the flush but havnt fitted them yet. Bro in law bought a set of plus flush for his mini boot but they don't look as good ( he's not as precise as me)

The Westfield kit uses a pin to locate the front so you only need a pair.