EEC IV problems - No start

[Enoch]

Hi folks, tried to start the car today but no joy whatsoever. I have the earths and +12 permanent and 12 v switched all going to the ECU but when I turn it on the pump does not run. If I measure the output from the ecu it seems to be trying to do something as it switches from 0 volts to about 0.35 volts for a couple of seconds. Looking at the Haynes diagram the pump relay has a live on one side, the ecu feeds the other side so I would expect to see 12 volts between pin 22 and the 12 volt terminal when first switched on.
Just to expand a bit I have earth on pins 16, 40 and 60, perm 12 volts on pin 1 and switched 12 volts on pins 37 and 57 of the ECU.
I have tried hooking up a strobe and there is no spark when cranking.
Am I missing something obvious? Everything looks connected up ok but I am scratching my head at the moment.
Thanks in advance,
Enoch