#1
|
||||
|
||||
Grub screws in uprights
Hi guys,
I think this has been asked before but i cant find it so... What size grub screws should I use to secure the mushrooms? Also will one on each upright do or should i use two or three. Or should i just drill into them and put a couple of small bolts into them? Thanks, Nathan
__________________
A few build photos... www.photobucket.com/ntsengineering |
#2
|
||||
|
||||
Hi Nathan
I am intending to drill & tap to a M6 metric thread & use a high tensile, set bolt. This will be coated with loc-tite prior to fitting ( Take a photos in case the IVA tester questions the locking method ) If you don't fancy trusting to a M6 bolt, up it one size to M8 . A single fixing in each upright is the minimum requirement for IVA.
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie www.roadster-builders.co.uk Last edited by Bonzo : 31st January 2011 at 07:00 PM. |
#3
|
||||
|
||||
cheers, il bolt them then, maybe one from the front and one from the back?
__________________
A few build photos... www.photobucket.com/ntsengineering |
#4
|
|||
|
|||
Just one m6 should be sufficient, my iva tester was happy with that
You dont dont want to be drilling too many holes in your uprights! The mushrooms are well and truly clamped in position by the pinch bolt anyway, the secondary fixture is just belt and braces As Ronnie says set bolts are generally a higher tensile strength should you feel the need to go one better than an ordinary bolt |
#5
|
||||
|
||||
Could use m6 stainless dome head bolt in each mushroom, if the clamp comes loose you will feel it straight away through the steering while the bolt holds the mushroom in place giving you ample time to add some loctite and clamp up the bolt again with a bigger spanner.
Mr IVA man is quite happy with that, but as said don't weaken the ali mushroom any more than need be. Andrew
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH |
Thread Tools | |
Display Modes | |
|
|