#1
|
|||
|
|||
Scuttle
Sorry if this is a silly question
I am about to strip down my chassis after mock up to paint and just had a thought. If I am fitting a fibreglass scuttle ( I haven’t bought it yet having no space to store it)do I have to put a frame work under the scuttle to support it welded to the chassis or do they support themselves Any advice would be greatly appreciated Rob |
#2
|
||||
|
||||
Quote:
Nothing to worry about......AndyH
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH |
#3
|
|||
|
|||
Thanks for the quick reply Andy that’s saved me a lot of work
Many thanks Rob |
#4
|
||||
|
||||
Can anyone tell me if i've got my scuttle in the right place?
I've found it's longer than the book one, so if the front lines up where it says in the book, then the dash end sticks out too much. Do i line up the chassis upright with the back corner of the scuttle (dash side) ?? Anyone got a pic??
__________________
~ My Build Diary - http://davesroadster.blogspot.com/ *updated 7/6/11* Best bit so far: Getting it running Worst bit so far: Cutting steel for wishbones and engine mounts. Most annoying bit so far: Generator packing up half way through welding. |
Thread Tools | |
Display Modes | |
|
|