#1
|
|||
|
|||
clutch arm pivot pin
I seem to remember something about clutch pedal travel not being sufficient in zetec installations.GBS do an extended clutch pin for the black top . Do you need this with the silver top , mondeo clutch and extended release bearing? I dont have any clutch pin in my box so I need to get one which do I get and if it's the std one, can I still get one from Ford do you think.
cheers tony |
#2
|
|||
|
|||
You will be lucky to get anything for a Type 9 from Ford,I wnated flywheel pins and they have been out of stock for years.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice. |
#3
|
||||
|
||||
I believe the Black top and Silver top are identical WRT the clutch. I also have a 1.8 flywheel, Mondeo clutch and the longer CCT133 bearing. The clutch actuation point not far from the bottom of the pedal movement, but it works well as it is, pretty much.
__________________
Albert Haynes Roadster FAQ | Haynes Builder Locations Gallery, build thread in Lithuanian / via Google Translate. |
#4
|
|||
|
|||
1600 zetec f/wheel is lighter and aparently the better one to use.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice. |
#5
|
|||
|
|||
cheers guys, so where do you think I could get pivot pin from then, Would the likes of Burton Power have one?
all suggestions welcome. tony |
#6
|
||||
|
||||
You mean this? http://www.bearingkits.co.uk/Clutch-...ousing/625.htm
__________________
Albert Haynes Roadster FAQ | Haynes Builder Locations Gallery, build thread in Lithuanian / via Google Translate. |
#7
|
|||
|
|||
Burton power stock them. I need one as I put it in a safe place but can't remember where that was
|
#8
|
|||
|
|||
GBS do an extended clutch arm pin than negates need for thicker release bearing
|
Thread Tools | |
Display Modes | |
|
|