|
|
#1
14th May 2012, 06:37 PM
|
|||
|
|||
For sale - exhaust can
I've got an exhaust can for sale. It's a Yamaha r1 can, with a 2" link pipe in stainless tigged to it. It's got rolled ends, and was measured at 97dB @ 75% power on my 2l Zetec, so should be fine for IVA. It comes with a mounting strap, and is totally ready to fit. It's got a few scratches from use, but no dents - its no worse than if you'd had the car on the road for a few weeks!
Looking for £60, and collection from Greenhithe, or I do a fair bit of work in SE London, so could meet someone somewhere. Cheers Adrian  Last edited by adrianreeve : 14th May 2012 at 07:19 PM. 
|
|
#2
14th May 2012, 07:04 PM
|
||||
|
||||
|
Adrian, random question, but where did you get the exhaust hanger from, the one on the rear of the exhaust with the punched holes?
__________________
1.8 Silvertop Zetec (ZX6R Carbs + Megajolt) + Type 9 My Build Blog: http://www.haynes.co.uk/forums/showthread.php?t=2736 - Last Update: 31st October 2020 Total Spent so far: Stopped counting 
|
|
#4
14th May 2012, 07:16 PM
|
|||
|
|||
|
Tatey
It came with the exhaust, so I guess Yamaha! Porkchop, sorry, forgot to put in the post - looking for £60 collected, or will post at cost. I also work a lot in SE London, so could meet somewhere. Cheers Adrian
|
|
#6
17th May 2012, 07:48 AM
|
|||
|
|||
|
Vern
Yes I did, I used the 3M Di-Noc stuff, and found it very satisfying to work with. I did the rear and side panels, tunnel top, fly screen and various accent pieces. There are some photos in my album which you can find in my signature. If you have any questions, feel free to ask! Cheers Adrian
|
|
#7
17th May 2012, 03:10 PM
|
|||
|
|||
|
Quote:
Yes I have seen the pictures of your car and very good it looks too. Did you have any previous experience of vinyl wraping? I'm looking to do some wrapping but I'm nervous about trying it as the areas I'm looking at have multiple curves. BV 
|
|
#8
17th May 2012, 07:02 PM
|
|||
|
|||
|
Vern
No previous experience, just took my time, and the Di noc is really good to work with. Compound curves are no problem, just need some gentle heat from a hair dryer. I managed to cover a pair of motorbike wing mirrors, and they're very curvy! Cheers Adrian
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
