#1
|
||||
|
||||
Aerocatches
Has anyone used any of these with a saturn bonnet? If so have you used the flush fit or exterior mounted ones?
__________________
Gallery 2 http://www.facebook.com/album.php?ai...4&l=a9831a9319 Gallery 3 http://www.facebook.com/album.php?ai...4&l=3f0d42c523 Gallery 4 http://www.facebook.com/album.php?ai...4&l=efb083b7df Gallery 5 http://www.facebook.com/media/set/?set=a.10150244028550325.366987.601005324&l=583fd5 cd3a Gallery 6 http://www.facebook.com/media/set/?set=a.10150550640070325.430417.601005324&type=1&l =fe779b358c |
#2
|
||||
|
||||
I was planning on using the locking ones but not sure about IVA?
|
#3
|
||||
|
||||
According to IVA, if the projection sticks out less than 5mm then the edges need to be blunted. According to the aerocatch drawing - http://www.aerocatch.com/updoc/Tech_...flush_dims.pdf if you use the ones that mount externally then they only stick out 2.5mm so should be ok.
The flush mount ones need a bonding plate so the bonnet would need to be less than 2.5mm thick.
__________________
Gallery 2 http://www.facebook.com/album.php?ai...4&l=a9831a9319 Gallery 3 http://www.facebook.com/album.php?ai...4&l=3f0d42c523 Gallery 4 http://www.facebook.com/album.php?ai...4&l=efb083b7df Gallery 5 http://www.facebook.com/media/set/?set=a.10150244028550325.366987.601005324&l=583fd5 cd3a Gallery 6 http://www.facebook.com/media/set/?set=a.10150550640070325.430417.601005324&type=1&l =fe779b358c |
#4
|
||||
|
||||
I pesonally think the top mounted ones would look better, but I think you need 2 sets to secure the bonnet properly?
I have been looking for an alternitive the the rubber things, they look awful |
#5
|
||||
|
||||
I bought a set of the flush but havnt fitted them yet. Bro in law bought a set of plus flush for his mini boot but they don't look as good ( he's not as precise as me)
The Westfield kit uses a pin to locate the front so you only need a pair. Last edited by SeriesLandy : 6th September 2010 at 10:01 PM. |
Thread Tools | |
Display Modes | |
|
|