|
#1
|
||||
|
||||
Fixing the nosecone
How on earth do you fix the nosecone to the chassis? Also, is it normal to have to cut the bottom down to make it fit? Mine sits 20mm forward because the bottom edge is too deep and strike the chassis rail in the middle.
|
#2
|
||||
|
||||
Quote:
i had to cut mine down on the bottom and your correct it lands bang in the middle of the bottom chassis rail. i welded two little tabs on each side of the bottom chassis rail and put to m5 bolts through. then i used two bolts on the top of the chassis rail. so all together there are 4 bolts holding the thing on. |
#3
|
||||
|
||||
Quote:
cheers andy
__________________
Flat Pack Chassis Kits for sale, contact me at andyroadster@yahoo.co.uk |
#4
|
|||
|
|||
Well I would say check the height of the chassis then as the mould can't shrink 12mm for one customer and grow back for the next......
|
#5
|
||||
|
||||
Quote:
I think I'll do what Ash did and pop some bolts in. I was going to try to rivnut it but I'll try something different. |
#6
|
||||
|
||||
I have some nice dzus fittings that im planning on using they have a nice radius are chrome and use a 4mm allen key was planning on two from below onto bracket on front lower chassis rail and one either side on to bracket on top rails.
still need to cut about my widened locost nose but its on the list of things to do somewhere in my head lol Ray |
Thread Tools | |
Display Modes | |
|
|