Haynes Forums  

Go Back   Haynes Forums > Haynes Roadster Forums > SVA/Legal
FAQ Members List Calendar Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Display Modes
  #1  
Old 29th January 2008, 01:03 PM
murpia murpia is offline
Junior Member
 
Join Date: Jun 2007
Posts: 6
Default SVA requirements for steering column

What are the SVA requirements for the steering column?

Reason being I was thinking of fabricating my own column arrangement rather than using donor parts. I know it's supposed to be 'collapsable' but what does that mean in terms of load etc. required to collapse? And how far?

Regards, Ian
Reply With Quote
  #2  
Old 29th January 2008, 01:31 PM
jabs jabs is offline
Member
 
Join Date: Apr 2007
Location: Knaresborough, Harrogate
Posts: 59
Default

This from the SVA manual

Reply With Quote
  #3  
Old 29th January 2008, 01:37 PM
Chris Gibbs
 
Posts: n/a
Default

These pictures might help too







All in all I think it would be difficult to meet the requirements with a home made column, but nothing is impossible.

Cheers

Chris
Reply With Quote
  #4  
Old 29th January 2008, 02:19 PM
murpia murpia is offline
Junior Member
 
Join Date: Jun 2007
Posts: 6
Default

Fig. 1 of the offset joints type was what I had in mind.

Is there a minimum angle or offset specified?

Thanks, Ian
Reply With Quote
  #5  
Old 29th January 2008, 02:50 PM
Chris Gibbs
 
Posts: n/a
Default

It's a minimum of 10 degrees, and as the SVA manual says "it is unlikely that joints of this type will work at angles above 30 degrees"

So it's between 10 and 30 degrees.

cheers

Chris
Reply With Quote
  #6  
Old 31st January 2008, 01:02 PM
CurlyBen CurlyBen is offline
Junior Member
 
Join Date: Jan 2008
Location: Suffolk, Southampton, Beijing...
Posts: 6
Default

One option might be to have the steering column as two tubes, one with an ID slightly greater than the OD of the other and drilling a hole through the pair and linking them with a shear pin of some kind. obviously you need to make sure it's not going to shear with steering forces! I've got an idea that would alleviate that problem but it starts making things too complicated. I think the above is essentially what's being done to the F750 car I work on, but we're buying it and I've yet to see it. We've also got a prop shaft at a hideous angle, probably over 30 degrees, and that's caused one failure so far! It'll also sap power and feel..
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 11:23 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.