#1
|
||||
|
||||
Rivets
What size rivets do I need for the floor, and where can I buy some online?
Thanks! |
#2
|
|||
|
|||
I used 1/8th for everything mainly since i had a big box full in the workshop but id say they are a good size.
not sure were is good to buy them since i didnt have to buy these
__________________
www.heraldic-motorsport.co.uk |
#3
|
||||
|
||||
I welded my floor on personally but shouldn't you also use an adhesive if you're using rivits?
|
#4
|
||||
|
||||
I used 4mm rivets for my floor, as Tilley, I used this size because that's what I had here
Here's a site for sealed rivets & all sorts of fasteners, prices are not too bad but the postage adds to the cost if your not spending enough to qualify for free postage. Sealed Rivets Hope that helps
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie www.roadster-builders.co.uk |
#5
|
|||
|
|||
When buying those rivets make sure that you get the right length, they need to fall into their grip range . To long and they dont bite and to short and they wont expand behind the hole.
http://allfastsolutions.com/pdfs/Rivet%20Chart.pdf Bob
__________________
When The Results Disagree With The Theory: Believe The Results And Invent A New Theory If I had two brains I,d still be a halfwit The cave http://s1116.photobucket.com/user/my...deshow/mancave The build http://www.haynes.co.uk/forums/showthread.php?t=12669 |
#6
|
||||
|
||||
Yeah, it's the length I'm worried about.
I'm going to use a 1.5mm ally floor, and I think my chassis rails are 2mm, but I'm not sure how much to allow for the sealant. |
#7
|
|||
|
|||
Dont over do it with the sealer or you will find the rivet will expand between the panel and the chassis, just a light bead really and use those panel holders to squash out the sealer before you rivet.
http://www.actechaero.com/images/polygone/clecos.jpg Bob
__________________
When The Results Disagree With The Theory: Believe The Results And Invent A New Theory If I had two brains I,d still be a halfwit The cave http://s1116.photobucket.com/user/my...deshow/mancave The build http://www.haynes.co.uk/forums/showthread.php?t=12669 |
#8
|
|||
|
|||
I would use 2mm for the floor as it doesn't take much for something to puncture the thinner ali sheet. I don't advise welding sheet steel on the floor either as this can lead to distortion if fully welded, yet if only stitched in place it allows water and road junk to get trapped even if you use seam sealer and it will rot out just like any other car.
|
Thread Tools | |
Display Modes | |
|
|