wishbones steel thikness

[squbti]

hi all , just wanted to know what thikness are the tubes for the wishbones? mine are 2mm & it seems after my first test i might have to change them for 3mm .what did everyone use?
thanks/samy

[3GE Components]

Hi Samy,

We' ve supplied a number of builders in Sweden with wishbone kits, ours use 2mm for the lower arms, we also supplied a certificate of conformity listing the material used, standard it conforms to, production batch etc etc, one customer did the calculations and the parts we supplied were satisfactory for the application.

Hope this helps

Kind regards

John

[squbti]

thanks john, i know that the 2mm wishbones are what alot if not most builders in the uk & in sweden have been useing but what can one do when the tester says he´s not sure its ok thats why i´d like to know what anyone else has used & if anyone knows what the roadsters disign was based on , was it disigned fro 2 or 3mm for the wishbones?
thanks /samy

[davedew]

I know the lower wishbone material myself and Gus used was 25.4 x 3.25 Seamless tube, which I think was what the book said to use.

Cheers

Dave

[squbti]

i couldnt find anything in the book about the thickness, does it say it anywhere?
samy

[3GE Components]

Just for confimation from the man himself

http://www.haynes.co.uk/forums/showt...tube+thickness

Kind regards

John

[rally205]

But the book shows the 25mm tube as being 3mm wall thickness in fig. 5.5 on page 58

[squbti]

thank you john that was just what i needed & it couldnt be better than to hear it the man himself .
cheers
samy

[chrisunwin]

Hi

Whilst on the subject of wishbones. Is there any reason that I cant make them from square tube? Reasoning that it is much easier to cut all the angles on square tube rather than all that messing about with round miters which are a real pain.

Regards

Chris

[Wynand]

mine were made from 2mm wall thickness tube 25mm OD.