Rosco's haynes Build

[Rosco]

More done today, loads of bits and bobs to do, got my clutch cable sorted, had to make a bit at the pedal end and solder a bit on the other end, it wouldn't solder to start with, to hot I think, but got it done in the end.

Also got all my aluminium engine cradle spacers back on and tightened up.

Then went down my dads and made my air filter backplate ready for the itg filter, I got a drawing from ITG for the outside



Came out mint





Pretty much there now, just need a few holes in it for wiring, air temp and the fuel feed, also need some 3mm spacers under the trumpets to replicate what was there before as it's got orings that seal everything

[Rosco]

Steering rack and track rods re fitted



When I re fitted the steering shaft my break pipe was in the way so I had to make a new one



Rear discs and pads fitted



Done a bit more on my inlet, fuel rail all fitted and fuel piped up

[Rosco]

I removed the pins from the injector plugs ready to pass through a grommet but then decided I'm going to cut the lot and put a connector inline so it's easily removed



Also my air filter came last week and fits sweet!

[Rosco]

Had a morning on my dads cnc today





These are to go under my trumpets on the inlet to replicate the thickness that was there before



Handbrake cable tags

[Rosco]

Works like a dream to!





This is a bracket for over the diff, just need some more grommets

[norton]

Is that a home brew cnc machine?

[Rosco]

Originally Posted by norton

Is that a home brew cnc machine?

Yes mate, it's wicked, he's built it all himself, it works a treat, considering I use real cnc mills all day at work, I prefer using his

[Rosco]

Well got a few jobs done this week, got my handbrake bracket fitted, really pleased with this as its held the cables dead in the right place



Decided on what switches I'm going to use for my dash, and got some switch guards, only thing there 4mm not 5mm so I think they will fail iva so I'm going to have to push some rubber tube over them I think



Also made a mount for my wheel speed sensor, there was a spare hole on the engine so I used this, it's going to pick up off a long bolt on the prop adapter



It sits closer than it looks, it's just the angle of the pic

[Rosco]

Right update time, been bitting and bobbing all week really

Rear lights temporarly mounted and wired to the front





Makeshift dash sorted so I can start to get things wiried



Battery cables done

[Rosco]

I'm using these terminal bars for my wiring



Toggle switches for my dash