|
|
|
|
#1
10th January 2010, 09:33 AM
|
||||
|
||||
Silly me. You'll need the 19mm reamer as the taper is 14-16mm if I remember correctly.
__________________
Website http://www.talonmotorfabrication.co.uk/ Direct email phil@talonmotorfabrication.co.uk talonmotorfabrication@gmail.com Mobile office hours 07514098334 
|
|
#2
10th January 2010, 09:37 AM
|
||||
|
||||
|
Quote:
 Yes 19mm and yes makes a good fit David
__________________
. . David. Heaven, Warm days and Cool rides 
|
|
#3
10th January 2010, 09:42 AM
|
||||
|
||||
|
and the taper angle is correct with those?
Cheers TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders
|
|
#5
10th January 2010, 09:55 AM
|
||||
|
||||
|
so when reamed, the OD of the lower hole should be at 16mm.
Cool. Cheers TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders
|
|
#6
10th January 2010, 10:03 AM
|
||||
|
||||
|
See, now you getting complicated.
 When I did mine I kept doing a bit then tested it, till I got about half the thread through. So when I tightened it up it pulled in snug without the thread bottoming out. Not sure, but think if you did it till the bottom was 16mm it may be too much. You will need someone that has done one recently to be sure.
__________________
. . David. Heaven, Warm days and Cool rides
|
|
#7
10th January 2010, 11:09 AM
|
||||
|
||||
|
i did mine as Dogwood suggests,
a little at a time, keep checking that you haven,t gone too far, takes about 10 mins per upright, do it like tapping a thread, half turn in quarter turn back.... keeps the cutting edge of the reamer clean of swarf & helps get a clean cut on the steel.  cheers andy
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
