|
|
#1
18th March 2011, 07:32 PM
|
|||
|
|||
Pics..Fuel and Brake lines ..Enough clips ??
Been hard at it today..had a rethink of my fuel feed and return lines so made a track for them to run down....i hate feckin microbore pipe it may be malable but in my big plates of meat it is CRAP hate it !!![IMG]
 [/IMG]   Have i clipped it enough...cant move the pipes unless you wedge them with a scewdiver !! There are a few bits of the petrol pipe i want to cover with split rubber but will need to scavange some tomorrow at work thing 6mm 4 core SWA insulation is about right  
|
|
#2
18th March 2011, 08:36 PM
|
|||
|
|||
|
More than enough should keep the man happy.
Oberservation and not critical,you could have put 2 clips on one rivet for the brake pipes at the front.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice. Last edited by flyerncle : 18th March 2011 at 08:41 PM.
|
|
#4
18th March 2011, 08:48 PM
|
||||
|
||||
|
Looks really good Andy, use of the rubber lined p clips always goes down well with the IVA man and the way you have rubber lined the copper tube at the corners looks good to.
Plenty of clips..... Andrew
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH
|
|
#5
18th March 2011, 08:52 PM
|
|||
|
|||
|
Ken the problem Andy,wee rivets are a pain.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#8
24th March 2011, 08:51 PM
|
|||
|
|||
|
DONT USE 3/8" MICROBORE !!! as i needed to do some tight 90 bends to look nice and neat around the engine bay...can you get 3/8" end feed or yorkie fittings....can you f@@k ...all my days work has been ripped out and ran in 10mm od pipe...on the bright side i have a supply of rubber petrol pipe which will fit over the microbore very snug...
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
