|
|
#1
15th November 2009, 05:53 PM
|
|||
|
|||
Engine mounts
I've made up the engine mount brackets em1-4 as per the book but like an ejut I assembled them incorrectly and have fully welded them to the chassis. Hopefully there will be picture below or an attachment. It does look a bit stupid but will it be ok.
Cheers Peter 
|
|
#3
15th November 2009, 08:04 PM
|
||||
|
||||
|
I nearly did that the other night but luckly saw ash's pic in ckc and realised it was wrong. It will be fine as long as the engine sits in the right place.
|
|
#4
15th November 2009, 08:07 PM
|
||||
|
||||
|
It will be fine as long as you enough of the plate supporting the engine mount for it to rest on......
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH
|
|
#6
15th November 2009, 09:20 PM
|
||||
|
||||
Me too
I done exacly the same thing Peter
 Didn't notice untill Ash pointed it out in another thread  Being as my chassis was already painted, I wasn't about to cut them off again. Totaly confident mine will be OK as is
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie www.roadster-builders.co.uk
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
