Milling Machines for Sale

[Spikehaus]

Gents

I have a couple of old manual milling machines for sale; not sure if they are any use to someone in their workshop? Just thought I would post hear as it's a great bit of kit if you have room for it.

It might me limited as they are 3 phase, but its simple enough to change the motor.

1 Nr Bridgeport Conventional Turret Milling Machine with readout - R8 Tooling

1 Nr Ajax Turret Mill with readout. Need to check Tooling

Looking for around £500.00 each and must be collected.

Also I need the space as I have 2 new machines arriving on Tuesday and don't want them left in my build area for to long!

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=220540744559&ssPageName=STRK:MESELX:IT#ht_542wt_1165

[HandyAndy]

i daren,t speak :o :D

we got 3 phase at unit :)

cheers
andy

quick enough Les???? :D

[Spikehaus]

Perfect for making chassis packs, I built my car on the Bridgeport. I will miss it

[AshG]

swap you one for a harrison lathe

[Spikehaus]

What size, model mate? ?? M300?

[AshG]

its a late 9inch swing 36inch long bed L5. mechanically its just as good as an m300 but its more rounded without the DRO's. i have got all the change gears and original accessories for it

it weighs about 1.3tonne which is the biggest problem.

its identical to this but all the white bits are green
http://www.paulmachinery.com/lathes/brook.jpg

[RAYLEE29]

That looks very similar to my harrison wich is donkeys years old nice to see a newer version
heres a pic of it hiding in the background very usefull lathe can skim brake discs if your carefull made all my wishbone bushes and cut fishmouths on tubes too and offset mushrooms etc
Ray:)

[flyerncle]

Somebody getting on your case Andy ? :)

[Spikehaus]

Only one left,

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=220540798796&ssPageName=STRK:MESELX:IT

Ash mail me, could do with another small lathe,

[AshG]

ok will do. she has been stored for ages as i have two. currently, the cross slide tail stock, chuck, motor, belt cover and suds tank have been taken off and dry stored indoors. lathe bed and bare metal bits was caked in grease prior to storing so she should be in good condition when i dig her out.

both of them come out of a school and were like new as they spent 20-30 years in a classroom covered up not being used

[les g]

i daren,t speak :o :D

we got 3 phase at unit :)

cheers
andy

quick enough Les???? :D

you,ll get deafened by the siren and blinded by the stobe
before you finish your car Andy lol
cheers les g

ps; did you do deal with Ginge then ????
sweet.... we,ve had the same saw for a good while now and its quite good indeed
we use ours for allsorts of things and the table to convert it to a scroll saw is just brilliant
we actually used ours once to trim a roll of roofing flashing to size
a lot easier than a pair of tin snips he.he