PDA

View Full Version : pinto to polo rad?


carlknight1982
7th December 2010, 08:38 PM
Im putting together a shopping list for my cooling system parts
what hoses have people used and what header tanks?

pics would be cool

gingea1pom
7th December 2010, 09:10 PM
Don’t talk to me about coolant hoses!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!

Top tip belt and braces and don’t use hoover pipes.:D

Cheers Ginge

twinturbo
7th December 2010, 09:23 PM
Had to reseat and rejubilee the top heater hose on the MK1 Golf this evening. It was only -5 outside....


I think your hose choice will be mainly down to personal preference and what you can source. The fewer joints the better.

TT

flyerncle
7th December 2010, 09:51 PM
Fit the nose cone if you have one and put the rad in to give you an idea of where to mount it,the inlet and outlet are close to the FF, position the rad for ease of fitting the pipes.

carlknight1982
8th December 2010, 06:36 AM
Nose cone and rad are fitted, im looking at how to plumb the system up and what i need to do it so i can order the bends etc from rally design in nice pretty silicon hose and the straights in beaded end ally. I dont fancy a trip to the hospital like AshG and Ginge!

spud69
8th December 2010, 08:40 AM
For a locost fix Carl, you can get a beading tool from B&Q, Metal Oyster Kit, can be hard to find but should be available in the large warehouse stores. It's about £12 and will put a nice bead on s/s hoover pipe, or you can get ariel extension tube from B&Q which is cheap and good for the job. I believe Mark has just gone down this route to replumb his car. Put together a list of bends required and go to local scrappy.

Much cheaper than silicone bends and beaded pipe. Everyone has there preference but if you do a search on Locost for the Metal Oyster Kit there is loads of info.

Regards....AndyH

carlknight1982
8th December 2010, 10:06 AM
I was hoping that dogwod would post some pics of his cooling system.