Suitable Flywheel? 1.8 Zetec Silvertop

[Tatey]

I am looking to find a suitable flywheel for my 1.8 silvertop zetec engine. Could anyone tell me if the following flywheel would be fine for my engine?

http://cgi.ebay.co.uk/1999-Ford-mondeo-1-8-Zetec-Flywheel-/280623887755?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item41567cb58b#ht_3648wt_975

Also could you tell me if the following ARP flywheel bolts are of a decent price?

http://cgi.ebay.co.uk/ARP-FLYWHEEL-BOLTS-FORD-ZETEC-2-0-1-8-1-6-ZVH-KITCAR-/290515416034?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item43a41173e2#ht_554wt_698

I will be ringing my local motorfactors and ford dealer at some point this week to order a clutch so would like to have a flywheel to go on my engine so I can finally install my engine/type 9 gearbox.

[mark]

Im unsure if there is a variation year on year with the flywheels

With regards to the bolts i paid about £15 for standard ford ones so thats not a bad price in my book for uprated ones

[baz-r]

i take it you have no orignal flywheel then?

1.8 cvh will fit but thay have no trigger holes so a trigger wheel needs fitting to run your crank pickup its light to

std 1.8 silvertop flywheel is what you want say if you have a 2L silvertop as the orignal is too big :D

[Tatey]

The engine didnt come with a flywheel so I am looking to find one which will cost me the least amount of money. I currently have a 1.8 CVH flywheel, what kind of work is involved with fitting one other than drilling the bolt holes from 10mm to 11mm?

[baz-r]

im told it fits and is light you can use the std cvh clutch and starter
problem is the zetec's have holes in the back of the flywheel used as a trigger wheel and the cvh 1.8 has a ring on the front pully what you would need to do is fit a trigger wheel to your frount pully run your ign/inj system as there is no form if distubutor for the zetec
or find a 1.8 zetec flywheel (no idea if 1.6 ones are any good?)
try locostbuilders forum