wiring

[misty]

Hi All
I would like to run over this with you all to see where i am going wrong
battery+ to large bolt on starter solenoid and from the starter solenoid to alternator, small cable from alternator to ign.

coil+ to dizzy and from dizzy to earth.

alternator to be earthed

run an earth cable from battery to gearbox

Now this is what i have done just wanted to check with you all to see if i am correct.

If i am wrong could you please let me know as i am an idiot so it would have to be idiot proof

many thanks

[brainbug007]

I'm not sure about this for certain, but I think you should have a thick red going from the starter to the battery+, a black/red going from the starter to ignition (it should change to black/blue by the ignition), a red going from the alternator to battery+, and then a thin blue going from the alternator to the instrument cluster.

I'm not sure about the coil/dizzy as my engine doesn't have that setup.

Yes you should have a thick black wire going from the battery- to a gearbox bolt.

[SeriesLandy]

I also had a blue wire going from the alternator to the auto choke.

On the coil, I'm sure the -ve went to earth and the +ve (green wire) went into the esc unit.

Not sure about the dizzy

PS dont take it as gospel, I've slept since then.

[baz-r]

er would depend on what engine and ign setup you have

only bit that sounds odd is the coil bit
usualy ign+ goes to coil+ then the cb side would go to the points that got the neg side conection from the dizzy body but meny later engins had eletronic ign to replace the points.
i think the ign + is still to coil +

[twinturbo]

Agree with BAZ on the coil.

+Ve must be an ignition live feed.
-Ve must be a wire to the correct control module for the engine ( ESC, ESC2, ESC-Hybrid,EEC-IV or TFI )

TT

[misty]

sorry should have said it is a pinto 2 lt engine, no fancy stuff ie ecu or anything like that hope this helps this engine has points

[misty]

meant to say also that on the solenoid there are 2 pillars and 2 spade terms can someone tell me what these are for please the large one is for the batt cable and the alt cable

[twinturbo]

Where did the engine come from? what connections are on the DIZZY?

can you get a pic of the solenoid?

TT

[twinturbo]

If the engine has points then there should be a condensor unit on the outside of the dizzy and a wire , this goes to the coil -VE.

TT

[misty]

great info will get pics tomorrow in daylight many thanks

[baz-r]

meant to say also that on the solenoid there are 2 pillars and 2 spade terms can someone tell me what these are for please the large one is for the batt cable and the alt cable

ok starter solonoid will have 2 big studs 1 in for the fat + cable from bat and one out that should still be conected to a short link to the motor.
then there is a smaller stud or terminal that works the solonoid its possible the extra one is linked to this

[misty]

Got It All Sorted
Many Thanks To All